You are here:
SKU: F18PD48P

F18PD48P

Self-Contained Refrigerated Dual Rail Prep Table with Flush Mount LiquiTec® Raised Rails

Take your operation to the next level in pizza prep by utilizing the benefits of LiquiTec® cooling technology. Dual rail prep tables have a second, elevated rail to improve production without adding to the footprint.

Description

Exterior Top
Constructed of one-piece 18-gauge stainless steel, with integral 2.12″ (5.4cm) high square nosing at the front. Top has two mechanically cooled LiquiTec® refrigerated raised rails at the rear with openings to accommodate pans (provided by others). Rail interiors are 22-gauge stainless steel. Raised rail openings have 18-gauge stainless steel hinged removable lids. Unit is equipped with separate expansion valve and on/off switch for refrigerated rails. Temperature in top openings maintains 33°F (1°C) to 41°F (5°C) with pans flush mounted at 86°F (29.7°C) ambient room temperature, meeting NSF 7 requirements.
Exterior Back, Bottom and Ends
Unfinished galvanized steel back and bottom. Exterior ends are finished with 22-gauge stainless steel.
Base Interior
Stainless steel back and bottom. Base interior sides and door frames are thermoformed ABS plastic. Each interior door section has (1) 25″ (63.5cm) deep removable epoxy coated wire shelf. Base is insulated with 2″ (5.1cm) high density environmentally friendly, Kyoto Protocol Compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming Potential) foamed in place polyurethane. End of base has a machine compartment with condensing units installed.
Door(s)
22-gauge stainless steel exterior front, with a thermoformed ABS plastic interior liner.
Refrigeration System
R290 refrigerant. Cabinet has (1) blower coil assembly with expansion valve on 48″ and 72″ models. Refrigerated base maintains temperature of 36°F (2°C) to 40°F (4°C). On/off switches for rail and base are located behind the louvered panel. A 2″ diameter hole is on the louver for easy access to rail on/off switch
Electrical Connections
115 volt, 60 Hertz, single phase. Unit is wired with 3-wire, grounded, maximum 8′ (2.4m) cord and plug.
Legs
Equipment is mounted on 6″ (15.24cm) legs.

Additional information

Power Input Type

Electric

Weight

691 lb

Primary Power Input

115-120 V x 60 Hz x 1 PH

Energy Use

10.1 Amps

Stainless steel end(s)
Laminate Back
Laminate End
Laminate facing (full front)
Locks
Tray Rack for 18″ x 26″ pans
Stainless steel back
Casters
27″ wide refrigerated drawers (2) high, holds 6″ deep pans
230V/50 cycle electrical: *Inclusion of this option will alter the electrical specifications
Remote refrigeration (contact factory)
Celsius readout for electronic control
Temp control viewing lens on mechanical housing
Variable cutting board types and sizes