Component Crafted Versa Drawer Equipment Stand
| Width x Depth x Height |
84"
x 303/4"
x 26"
(213.36 cm x 78.11 cm x 66.04 cm)
|
| Weight |
520 lb
(235.8720 kg)
|
| Power Output |
6
Amps |
| Exterior Top |
Constructed of one-piece heavy-gauge stainless steel with integral 2.12ÂÂÂÂÂ (5.4cm) high square nosing at front and 2ÂÂÂÂÂ (5.1cm) x 4ÂÂÂÂÂ (10.2cm) backsplash at rear. |
| Exterior sides, back and bottom |
heavy-gauge stainless steel sides with removable stainless steel mechanical access panel on compressor end. Back and bottom are constructed of galvanized steel. |
| Interior |
Interior of each drawer section is a polyethylene rotocast liner with ABS drawer front liners |
| Drawers |
Heavy-gauge stainless steel exterior front, with a thermoformed ABS plastic interior liner. Frame and tracks are constructed of 11 and 12-gauge stainless steel. Roller track assemblies have self-lubricating DelrinÂÂÂÂÂ rollers. |
| Refrigeration system |
Environmentally friendly HFC404A refrigerant. Each independent drawer has itÂÂÂÂÂs own evaporator coil with expansion valve. Digital control acts as thermometer, thermostat and diagnostic center for each drawer. Hot gas defrost system is also utilized during thaw operation. |
| Electrical connections |
115 volt, 60 Hertz, single phase. Unit is wired with 3-wire, grounded, maximum 8ÂÂÂÂÂ (2.4m) cord and plug. |
| Energy Use | 1.50 KWh daily |
| Certifications |
|
|