Please Note : You may require Adobe Acrobat Reader to view these documents.
Self-contained compact work top refrigerators
Width x Depth x Height
(121.92 cm x 71.91 cm x 100.33 cm)
Exterior top shall be one-piece, 22-gauge stainless steel with front edge turned down to form nosing and rear edge turned up to form a 4" (10 cm) high backsplash. Exterior back and bottom shall be one-piece, 24-gauge galvanized metal. Exterior ends shall be 22-gauge stainless steel.
Base interior shall be one-piece thermoformed ABS plastic material, with integral shelf supports. Cabinet shall have (4) epoxy-coated wire shelves installed. Base shall be fully insulated with high-density foamed-in-place environmentally friendly, Kyoto Protocol Compliant, Non ODP (Ozone Depletion Potential), Non GWP (Global Warming Potential) polyurethane.
Doors shall have a 22-gauge stainless steel exterior, with a thermoformed ABS plastic interior liner, and shall be fully insulated with foamed-in-place polyurethane. Door handles shall be black, recessed ABS.
Electrical connections shall be 115 volt, 60 Hertz, single phase. Unit shall have a 7' (2.1m) long electrical cord and NEMA 5-15P plug. Cord and plug shall be located on rear of cabinet, 16" (41 cm) above floor, 12" (30 cm) from the left.
Refrigeration system shall use HFC-404A refrigerant. Compressor shall be 1/5 h.p., with condenser coil and hot gas condensate evaporator mounted on rear of cabinet. Evaporator coil shall be mounted on the interior rear wall of the cabinet. Temperature control shall be mounted to the exterior rear wall of the cabinet. Refrigerant flow shall be controlled by a capillary tube. Cabinet shall maintain 36°F to 40°F (2°F to 4°C) interior cabinet temperature.
Equipment is mounted on 6" (15cm) high metal legs with black enamel finish.
2.37 KWh daily
NOTE: Certifications may differ with various options available for this product. Please check Technical Specifications tab for additional information.
Refrigeration system is designed so that air will flow under the unit, through the compressor area and out the front of the unit. Any restriction to this air flow path will void the warranties.
Air flow through the louver on the back of the unit is not necessary for operation, however, any air which passes through the louver is beneficial.
See Downloads for warranty info.
Stainless steel back
Plastic laminate on front
Additional wire shelves
Stainless steel single-tier overshelf
5" (12.7cm) diameter casters
220 volt, 50 Hertz electrical system
Self contained refrigerated work top table with backsplash